If you are using LibCode 7 Stage 3 then you will need to read this…

This procedure is set up to ensure that your backups are all completed in one session.  These backups include External Backup, Alternate Backup and Main Backup.  The All-in-One backup usually takes about five minutes to complete so you should run this at the end of each day in which you use LibCode.

To start the Backup:

1. Go to Utilities > Backup/Restore > All-in-One Backup

2. Click Yes to confirm that you want to run the three backups: External, Alternate, and Main.

3. Ensure that you have a USB in the drive then click OK to do the External Backup (the current date/time folder will be created automatically).

4. Click OK to proceed.

5. The Alternate Backup screen shows the drive to which the Backup is going to be saved (this needs to be a Local or hard Drive on the computer). If this is not correct, you will need to Browse to fix it.

6. Then click OK.

7. The Main Backup screen asks if you would like to skip a few processes (only tick this if you are really pressed for time, remember the whole procedure takes about five minutes!). Then click OK.

8. The next screen asks if you would like to do maintenance on the Data Files, click Yes.  (No still does a backup but with no cleaning up of files.)

9. The last screen shows that Backup was completed successfully.

If this is not the case or if the Backup was interrupted, then please call LibCode Support on (07) 4638 9025.